Measured comfort for Pinebrook
Ductmoor treats your HVAC as a linked system: outdoor unit, indoor coil, duct network, and controls. We document readings so you can compare season to season.
Services
- 01
Load and balance tests
We record supply and return temps per zone to spot rooms that over- or under-perform.
- 02
Compressor inspection
We measure amp draw and line pressures when the outdoor unit runs in heat and cool modes.
- 03
Blower motor service
We align belts or ECM modules and verify cubic feet per minute at the main trunk.
- 04
Control board diagnostics
We read fault codes, test relays, and confirm staging calls match thermostat commands.
- 05
Humidifier maintenance
We flush pads, check solenoids, and set output to match your indoor dryness level.
- 06
Zoning retrofits
We add dampers and second stats so finished basements and additions get their own schedules.
How it works
- 01
Baseline data from you
Send model numbers if you have them, plus recent utility use. We load that before the truck rolls.
- 02
Instrumented site walk
Techs carry manometers and infrared guns. You see numbers, not guesses, at each register.
- 03
Report and action list
We email a short summary with prioritized tasks. You approve items before parts are ordered.
Areas served
- Pinebrook
- Ductmoor
- Coldstream
- Mariner Point
- Vista Knoll
- Elmwood
FAQ
Do you replace only one part of a split system?
Sometimes. We match indoor and outdoor sections for efficiency ratings and refrigerant type before recommending a partial swap.
What is static pressure and why measure it?
It shows how hard the blower works against ducts and filters. High static often explains weak airflow upstairs.
Can older thermostats stay in place?
If they hold temperature within a degree or two, yes. We calibrate or suggest upgrades when drift is large.
Contact
Serving Pinebrook. Office hours on weekdays. Field visits booked in morning or afternoon windows.